HOME     

Updated 05/10/08

web page visitor statistics

                                The Turk Burner Project

I've been interested in this burner for awhile so over one day I made a working Turk.

This required a visit for an hour down to the local scrap yard to hunt for the elusive parts.

These were--- A piece of 4 inch diameter stainless steel pipe about 6 inches long, a piece of

3 inch pipe about a foot long and an old fire extinguisher plus some bits of stainless steel.

In addition to this two PC fans were bought and an old 8 inch diameter stainless steel cooking pan

was found lying around at home.

Turk 1    Photobucket

 

The top of the fire extinguisher was removed, the handle from the pan was cut off and they

were welded together, not a pretty site ! The top of the fire extinguisher was cut so the 4 inch pipe fitted.

Photobucket    Photobucket

 

The 4 inch stainless steel pipes bottom then had a piece of stainless steel  welded over it then 75 holes

were drilled in it 2 inches from the bottom in rows of five with half inch spacing.

The 3 inch pipe was then cut to fit tangentially to the pan and welded on followed by the making

of an end plate for it to hold the PC fan.

When it was completed I lit a small piece of paper, dropped it in the bottom, poured a little veg oil in

then turned the fan on. All worked well but a small piece of steel was inserted to deflect the air

so it came out of the holes equally and a speed control type fan was fitted to control air flow.

Below is the burner alight and 2 videos. Temperature reached about 300°C.

 Photobucket    Photobucket

        Night time drip fed using veg oil                                Day time drip fed using veg oil                   

 Photobucket    Photobucket

                       Night time using veg oil                               Night time using waste engine oil

 More forced air is required to eliminate smoke when using waste engine oil.

The residue consisted of ash comprised of the paper used to initially start the burner.

       

During the beginning of October 2008 a boiler was made to test on the burner, the results came out like this.

Over a 2.5 hour run with water in a continuous loop but there was probably at least a 50% heat loss.

Starting with 12°C ambient water temperature,68°C finish.

Fuel was waste motor oil, consumption was approximately 0.5 to 0.75 litres per hour with little if any smoke.

Here's a quick video of it in action.